6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 1 of 4 Posts

· Registered
506 Posts
Discussion Starter · #1 ·
Seems like there's some pretty knowledgeable guys around here so I thought I'd ask and see what responses I get. In 1994, I was in a gun shop and saw an XP-100 "Hunter" in 7mm-08 that I really wanted. At the time, $750 was outrageously expensive to me, so I didn't get it - but I did pick up a catalog. Turns out they only made that specific model of XP-100 for one year. Years later, I started looking for the XP-100 again. As most of you know, this model went through some serious revisions and was eventually dropped. I've always kept my eye open and hopes up that I might find one at a show someday. Anyway, I ran across this catalog when cleaning periodicals out of my reading room the other day and though what a wonderful pistol to have in 6.8. Any ideas on where to start a project such as this? I'm not scared to spend a little cash now to get what I want. That said, I've often looked at an HS Precision P2000 as a substitute and $2200 is still a little hard to swallow for what amounts to an accurized 700 action, a pistol stock and a 15" barrel. If I'm going to go full blown custom, I want a left handed action....

Here's a scan of the catalog pic:

1 - 1 of 4 Posts