6.8 SPC Forums banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,019 Posts
Discussion Starter #1
Title says it all. I need an open ended USGI type barrel nut wrench to work on barrels with pinned FSBs/gas blocks. My PRI doesn't allow this. I thought about cutting out a chunk of the wrench but decided I don't want to. So, if you've got a USGI wrench and would like to trade please let me know. The PRI sells for a little more than USGI so I think a straight swap is good.
Thanks.
 

·
Registered
Joined
·
1,019 Posts
Discussion Starter #2
Found one!!! Lock it up.....
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top