6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 11 of 11 Posts

· Registered
9 Posts
Discussion Starter · #1 · (Edited)
WTS: Stag 6.8 upper 5H 16" M4 w/ mag

After putting this up months ago, having buyers back out, facing many low ball offers and a couple of scam attempts I lost interest in selling… after all it wasn't costing me anything no keep it!
Now needing funds to support new project I am re-listing...

Started accumulating pieces for 6.8 carbine last spring (March 08), but did not complete in time for Whitetail season.
It is new and I have never fired this upper.
Specs on upper can be seen on the stagarms.com website.
Basics = flattop, railed gas block, A2 FH
Includes bolt, carrier, charging handle
This is an older model as is stamped 1:10 on barrel near gas block.

As shown in image, also includes:

2) Armalite 1" scope mount
- model EX0027

3) Leupold Ultralight 3-9x33 scope with LR reticle
- model 63080, you can check it out at leupold.com or riflescopes.com for more details/pics

4) Butler Creek Blizzard Scope covers
- clear see thru / flip up type

5) Single magazine as shipped from Stag. (I think it's a 25 round?)

AMMO NOT INCLUDED!!! (already sold)

$1150 Shipped Insured.
* Do not wish to split up at this time.
* No trades at this time.
* Know your local laws, do not buy if you cannot own/use in your location
USPS MO preferred payment ONLY.

Please email if interested: [email protected]

Thanks for looking.

· Registered
9 Posts
Discussion Starter · #5 ·
Re: WTS: Stag 6.8 upper 5H 16" M4, package - SPF

Original seller backed out and I forgot to update this thread...

Stag upper, bolt w/ carrier, charging handle, and mag again available.
(ammo, scope, and mount removed)

$750 shipped.
USPS MO, or discreet paypal + 3%.
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.