6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 1 of 3 Posts

· Registered
449 Posts
Re: WTS Phantom Flash Hider for 6.8

Darn the luck, I just ordered one from Brownells and his price is a buck or two lower than dealer pricing from Brownells.
And, if you want this to fit a .458 SOCOM these jewels only require you run a half-inch bit in from the scalloped end. The center is bored 1/2 inch and acts as a guide for the drill bit and you end up with a C2 that fits the .458 SOCOM (so long as it has Marty's or TROMIX's 5/8-24 threading and not the RR 5/8-36) and the hole is perfectly centered.
1 - 1 of 3 Posts