6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 9 of 9 Posts

· Registered
Joined
·
1,787 Posts
Discussion Starter · #1 · (Edited)
WTS or WTT 6.8 upper SOLD(PENDING FUNDS)

SOLD PENDING FUNDS

$500 plus actual shipping

Dpms Upper receiver
Pre 16" XT barrel (non chrome) from AR performance
Phantom Comp/Brake
YHM mid length light rail
Railed gas block
New 6.8 stag bolt
New firing pin, cam pin, firing pin retainer


I built this before my xtremes came in. All it needs is a charging handle and bolt carrier w/ key. It has some scuffs on the flash hider and gas block where I removed them and put them on this build. The could easily be touched up with a gun blue(black) pen.

It does not come with charging handle and bolt carrier.

I'll consider trades. Scopes, handguns, auto shotguns.







 

· Registered
Joined
·
1,787 Posts
Discussion Starter · #4 ·
It shoots well. I've only put around 100 rounds through it. I had an eotech on it so I didn't ever shoot it for accuracy. Just load testing and shooting steel targets.
 

· Registered
Joined
·
57 Posts
Cool...I wasn't sure how the pre XT barrels shot is why I was asking. As long as it slings lead I think I will be happy. Been looking for an upper to put on my Cavalry Arms lower for about 4 monts now. This will get my foot in the dor of the world of 6.8SPC.
 

· Registered
Joined
·
1,787 Posts
Discussion Starter · #6 ·
Groups at 100 and 200 yards

I've been out bushhogging all day and figured I would shoot some groups to show what it will do. I only had 10 rounds of the same load with me. I used three to get it on target. Then I fired a three shot group at 100 yards. Then I drove back to 200 yards and shot a group of four. I was shaking from riding the tractor all day. I'm sure I was the limiting factor. I used a Leupold 3.5 to 10 scope. I used the target that we use for our forum competitions. I believe if I wasn't vibrating from the tractor I could have squeezed a little better groups out of it. It's a nice shooting upper.

Loads were ;
New SSA Brass
CCI 4 primers
29.5 grains of reloader 10x
110 pro hunters


100 YARDS



200 YARDS



Here is a picture on my favorite lower.

 
1 - 9 of 9 Posts
Top