6.8 SPC Forums banner
1 - 1 of 1 Posts

· Registered
25 Posts
Discussion Starter · #1 ·
This is going up to fund a 5.56 AR project, I need something cheaper to shoot until I get my reloading press.

I bought two of these from Tony of Tony's Custom Uppers last time he was at the Mason Gun and Knife show here in Michigan. http://www.tonyscustomuppers.com

Ended up selling the other uppers barrel and replaced with a Cardinal Armory (Ko-Tonics at the time) 16 inch mid length barrel.

The upper is unfired and includes the bolt carrier group even though I forgot to put the bolt in the picture.
It has been installed on a DPMS lower to check fit and see how it felt in my grubby hands but has not been shot yet.

The barrel is 1:10 twist and from my understanding Tony has them custom made per his orders. CAR length gas system with M4 profile barrel, standard A2 birdcage flash hider. I have no idea what chamber the barrel has.

Included is a DPMS 6 position stock taken off another 6.8 rifle that now sports a sully stock. Needs a new castle nut, spring and buffer.

Upper was $550 with the BCG.
I'm asking $475 shipped anywhere in the CONUS via Express mail.
$375 shipped if you don't need the bolt but want the carrier.
Discreet paypal or Postal MO is fine, no charge on the paypal.

Only place I have feedback is on ebay, user name is tedfs3 .

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.