Joined
·
1,610 Posts
"Start the Roll Pin and drive it in the Roll Pin Base until it almost is visible at the other side. Install the the Carrier and Bolt release Spring then the Plunger first and the Release. Once you confirm the holes are aligned use a 3/32" Roll Pin Punch. * Using the proper punch will be a less risk of damage to your lower. Roll Pin Punches are designed to work with Roll Pins and not slip off"
I need the roll pint which goes into the bolt release. If you have a spare, let me know what you want, I can PP you the funds etc, I have spare parts to trade just not a spare roll pin for this part of the lpk build.
I need the roll pint which goes into the bolt release. If you have a spare, let me know what you want, I can PP you the funds etc, I have spare parts to trade just not a spare roll pin for this part of the lpk build.