6.8 SPC Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
900 Posts
Discussion Starter · #1 ·
EU0240MPKIT. Looks like they quite making these. Any one have one to sell?
 

·
Registered
Joined
·
900 Posts
Discussion Starter · #3 ·
There is a brand called DEZ that makes one but its attached with 5 set screws. I hear it works out fine but Im not convinced
 

·
Registered
Joined
·
844 Posts
EU0240MPKIT. Looks like they quite making these. Any one have one to sell?
Not what you asked for, but I drilled and tapped two holes for setscrews in a similar unit that hadn't been drilled for the taper pins. After zeroing the AR with the FSB, use 620 Loctite for a very rigid assembly. It will flow under the FSB and is heat resistant.

http://www.midwayusa.com/product/2351410205/doublestar-a2-front-sight-gas-block-with-bayonet-lug-ar-15-lr-308-steel-matte

[url]http://www.midwayusa.com/product/171860/loctite-620-retaining-compound-10-ml

[/URL]
 

·
Registered
Joined
·
900 Posts
Discussion Starter · #5 ·
Not what you asked for, but I drilled and tapped two holes for setscrews in a similar unit that hadn't been drilled for the taper pins. After zeroing the AR with the FSB, use 620 Loctite for a very rigid assembly. It will flow under the FSB and is heat resistant.

http://www.midwayusa.com/product/2351410205/doublestar-a2-front-sight-gas-block-with-bayonet-lug-ar-15-lr-308-steel-mattehttp://www.midwayusa.com/product/171860/loctite-620-retaining-compound-10-ml
Yes I have thought of that and I have one F marked
just like it. If I dont find a clamp on ,i'll place four 8-32x5/8 set screws on the sides. That should be good enough
 

·
Registered
Joined
·
1,065 Posts
My WOA match upper is set up with 3 set screws, two on the sides forward and one aft, underneath. Works just fine. My #2 match upper has 5 set screws simply because the barrel has 4 flats for windage adjustment.


-Alexander
 
1 - 7 of 7 Posts
Top