6.8 SPC Forums banner
1 - 7 of 7 Posts

·
Banned
Joined
·
2,342 Posts
Discussion Starter · #1 ·
a friend needs used, or shot out, or demilled A2 profile barrels, he also said he could use a couple of M4 barrels. have to be 5.56 not stainless or exotic finishes. plain jane usgi black. have to be cheap. worn out is good
 

·
Banned
Joined
·
2,342 Posts
Discussion Starter · #4 ·
usgi lengths, 20", i mentioned A2 and M4 and should have hi-lighted i meant Profile. sorry to have caused confusion, shouldn't have thrown M4 into the mix.

when i say "used" i mean "worn out" / damaged / cut in half,,,any condition other than serviceable
 

·
Registered
Joined
·
2,575 Posts
Mine is thoroughly abused. It was the test barrel for A large manufacturer of ammunition. But it is 14.5 inch…


Heinous typos thanks to autocorrect.
 

·
Banned
Joined
·
2,342 Posts
Discussion Starter · #6 ·
Mine is thoroughly abused. It was the test barrel for A large manufacturer of ammunition. But it is 14.5 inch…

Heinous typos thanks to autocorrect.
i'm going to see him tonight, i'll ask if he's interested
 

·
Banned
Joined
·
2,342 Posts
Discussion Starter · #7 ·
still looking for worn out barrels
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top