6.8 SPC Forums banner
1 - 3 of 3 Posts

· Registered
13 Posts
Discussion Starter · #1 ·
Purchased new from Tim about 2 months ago. I have fired exactly 160rds in the course of 5 range sessions. Rifle bore was cleaned after every 5 rounds cleaning from chamber to muzzle (direction of bullet path).

Upper has very little signs of wear and has not been altered from its original configuration.

Here is the most current picture:

Information borrowed from Tim's website:
-Stag Arms M4 upper receiver with M4 feedramps
-Improved SAAMI-spec chamber to handle the hottest 6.8mm SPC loads
-Four groove button rifling, 1:11" rate of twist, for higher velocity and great accuracy
-All barrels are 4140 chromoly with chrome-lined chamber and bore for easy cleaning and long-life.
-Mid-length gas port for lower cycle pressure and increased reliability
-M4-type feed ramp cut in the barrel extension and receiver for smooth feeding
-5/8-24 threaded muzzle, the standard thread size for 6.8 and .308 muzzle devices
-one-piece YHM free-float forend

Please keep in mind my upper has been cared for like a child, the pictures should reflect that as well.

Will take $500 shipped via USPS Money order or Paypal + 3.5%

This is a STEAL when you consider Tim is charging $555 + $28 for the A2 hider and shipping. Also, he builds each one himself so you may be waiting a week or two. This is ready to go today!

PS You only get the upper with the A2 flash hider-no bolt carrier assy, no rail covers, no verticle grip, no scope, etc.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.