6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!

Smith needed to cut and thread a barrel...

1225 Views 6 Replies 4 Participants Last post by  moose-hunter
I'm in the middle of an SBR upper project in .223 for my lil' lady to use. I'm having a tough time finding a 10" or so barreled upper so I'm thinking of taking another route...

Since this is a "budget" build, I'm thinking of just picking up a "cheap" 16", carbine gas length upper or kit and just having the barrel cut and threaded... Is this a good option? And does anyone know a good smith that is not swamped right now?

Hey Constructor... Would you like to tackle this quicky job? Or Tim? Or anyone? :wink:
1 - 1 of 7 Posts
You just cant find a barrel in stock or you cant find one at all?
1 - 1 of 7 Posts