6.8 SPC Forums banner
Cancel
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!

Smith needed to cut and thread a barrel...

1224 Views 6 Replies 4 Participants Last post by  moose-hunter, 
moose-hunter
I'm in the middle of an SBR upper project in .223 for my lil' lady to use. I'm having a tough time finding a 10" or so barreled upper so I'm thinking of taking another route...

Since this is a "budget" build, I'm thinking of just picking up a "cheap" 16", carbine gas length upper or kit and just having the barrel cut and threaded... Is this a good option? And does anyone know a good smith that is not swamped right now?

Hey Constructor... Would you like to tackle this quicky job? Or Tim? Or anyone? :wink:
Reply
Save
Like
1 - 1 of 7 Posts
B
Having a barrel shortened by ADCO is very easy.

8)
Reply
Save
Like
1 - 1 of 7 Posts
6.8 SPC Forums
A forum community dedicated to 6.8 SPC firearm owners and enthusiasts. Come join the discussion about optics, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
6.8 mm Firearms Discussion 6.8 SPC Ammunition & Reloading General Discussion Hunting with the 6.8 mm Accessories (Mags, Optics, Slings, Grips, Stocks)
Top