6.8 SPC Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter #1 (Edited)
Finally made it to the range today, been trying for 2 months. Had to test multiple rifles out and two pistols. Report as follows-

16” Socom 6.8 ARP build- still in progress but functions well, bolt locks back and cycles fine, still throws brass at the 2-2:30 position. A heavier buffer will finish this off I believe, I’ve tinkered enough and I’m pretty confident. Definitely Moa with factory S&B.
 

·
Registered
Joined
·
72 Posts
Discussion Starter #2
Well, rather than go through the buffer weight drama I just opted for the adj gas block. Got a Superlative Arms adj. gas block on the way. Looking forward to finally having this build dialed in.
 

·
Registered
Joined
·
5,571 Posts
Well, rather than go through the buffer weight drama I just opted for the adj gas block. Got a Superlative Arms adj. gas block on the way. Looking forward to finally having this build dialed in.
I agree but it only address overgas issues not under gas. I am sure you know this but never know who is reading.
 

·
Registered
Joined
·
72 Posts
Discussion Starter #4
It’s definitely over gassed, there’s no question about it.
 

·
Super Moderator
Joined
·
22,097 Posts
  • Like
Reactions: JW82
1 - 5 of 5 Posts
Top