[RoAus]

My Lee case length gage is trimming my brass to an OAL of 1.678". Am I ok at this length or do I need to go lower. I've been taking the case out of the lock stud and manually placing it on the cutter to get the .002" off the case and this is kill my time. I know some on here wait and trim the brass when it gets to 1.680". Am I ok at this length, cause if not I've got to find a file that will take .002" off this case length gage and it's some hard stuff!

My chamber is SPC II

 

[dlance13]

My Lee case length gage is trimming my brass to an OAL of 1.678". Am I ok at this length or do I need to go lower. I've been taking the case out of the lock stud and manually placing it on the cutter to get the .002" off the case and this is kill my time. I know some on here wait and trim the brass when it gets to 1.680". Am I ok at this length, cause if not I've got to find a file that will take .002" off this case length gage and it's some hard stuff!

My chamber is SPC II

1.686 is max length
1.676 is trim to length

You are fine at 1.678.