6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 1 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I've built a few AR15's 5.56 and now I ready to build a 6.8 SPC, 458 SOCOM, and a 9mm pistol (starting with the 6.8 first). I've only been pinging around for a couple of days but this is what I'm thinking for a parts list:

1. VLTOR MUR upper receiver
2. 18" 6.8 SPC WOA SS barrel with SPCII chamber
3. LMT 6.8 SPC MP inspected bolt
4. Chrome bolt carrier - LMT/CMT any other ideas?
5. JP Enterprises FF Rifle Handguard or a DD that covers the gas block
6. PRI QC Stainless Steel Muzzle Brake
7. Gas block that fits under the handguard, any ideas?
8. Stag Stripped Lower
9. Stag lower parts kit
10. 2-stage trigger Grissele, LMT, Timney, McCormick, etc. what order would you rate them?
11. Standard charging handle
12. Mid-length gas tube
13. LaRue Cantilever Mount
14. High quality 4-12x scope, maybe Leupold
15. C-products magazines
16. A rifle length stock not a standard A2 though or collapsible, any ideas?

Cool Real Tree Hardwoods camouflage job, not on the barrel though I like the look of stainless.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.