6.8 SPC Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter #1
I'm setting up for loading TAC 30 (ARP barrel). I ordered the 30 Herrett FCD. When reading thru the thread on this caliber there seemed to be some using the 7.62x39 FCD. It became more confusing with the use of shims also. What is the preferred FCD to use on this cartridge?
 

·
Registered
Joined
·
29 Posts
Discussion Starter #4
Thanks. I have the 30 Herrett die on the way. Well within a couple of weeks with the delayed shipping. I needed confirmation that I had the correct die for this altered cartridge.
 

·
Registered
Joined
·
54 Posts
I just saw your question. If you haven't already discovered on your own, yes, the 7.62 x 39 fcd works just fine for theTAC 30.
 

·
Registered
Joined
·
29 Posts
Discussion Starter #6
Thanks I'm getting along fine with the 30 Herret. I set it to close the collets when viewing from the top of the die. I can't tell that its doing a lot, but I feel it makes them more consistent if needed and doesn't hurt anything if not needed.
 
1 - 6 of 6 Posts
Top