6.8 SPC Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
92 Posts
Discussion Starter · #1 ·
Hi all,

I have a Hornady lock-n-load AP progressive press along with the case feeder. I use it for both larger (308, 6.5 cm) and small case (.223) load up my match ammo. I also shoot 6.8, and I recently acquired a 240 tomahawk upper that uses necked down 6.8 cases. The problem I am having is with the case feeder drop tubes. The small tube is too small for the 6.8 cases, but large tube is too big such that it causes the cases to sort of wedge against each other and not feed consistently. Obviously, the right answer is a Medium sized tube, but Hornady doesn't seem to offer one.

Does anyone else use a progressive press with a case feeder for 6.8 sized cases and if so, how did you overcome the issue I am having?
 
1 - 2 of 2 Posts
Top