6.8 SPC Forums banner
Cancel
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!

Homemade M4 feed ramps seem to be working

1985 Views 18 Replies 10 Participants Last post by  paulosantos, 
Float Pilot
I had enough of my Stag failing to feed the 90 grain HPs and the 100 grain Rems. So I went nuts the other night and made some M4 style feed ramps. Plus I de-burred everything else and polished the crap of of everything.

I took it out today and intentionally loaded up some 90 grain sierras much shorter (2.195 COL) than the riffle used to like and ran them through with no problems. Then I did the same for the 100 grain Remingtons. They sailed through without a hitch

I have some PRI mags coming as well to replace the 6 C-mags. I am sure part of my problem was the C-mags as well.

The new feed ramps seem to have helped with the first and last round flyers. Although they are still there, they are much closwer to the main group now.
Reply
Save
Like
1 - 1 of 19 Posts
S
So I have a stag 5.56 upper that should be here any day now. Is there anything I can or should do to fix this problem? Hopefully it isn't as big of a problem with the 5.56.
Reply
Save
Like
1 - 1 of 19 Posts
6.8 SPC Forums
A forum community dedicated to 6.8 SPC firearm owners and enthusiasts. Come join the discussion about optics, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
6.8 mm Firearms Discussion 6.8 SPC Ammunition & Reloading General Discussion Hunting with the 6.8 mm Accessories (Mags, Optics, Slings, Grips, Stocks)
Top