6.8 SPC Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all. First post here for me. I am from Garland Texas and completed my first AR build a few weeks ago in 5.56. I have a Stag 6.8 upper on order and will be switching topends for now until I can afford to build a dedicated lower to go with it. I look forward to learning a lot from you guys and maybe catching up to any local at APG or somewhere else for a little shooting.
 

· Registered
Joined
·
3 Posts
hello hogfan im just over 100 miles se of ya, shooting ar platform rifles and making dead hogs is my thing. its good to see ya join up here, i dont measure up to most of the folks here, they offer alot of help.i wish i found these guys before i went 6.8, i found them cause i needed help with my 1 in 10 twist, non-grouping rifle, with help and reloading im getting 2400 fps tearing 1 hole at 50 yds.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top