6.8 SPC Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi all,

I recently joined the forum here, though I have been reading here occasionally for a while. I worked for a company that had a 6.8 for testing. Messing with it a bit kinda pushed me off the fence to get my own. I had been halfway following the cartridge since it came out anyway. So I started building a 6.8 SPC, to try out the caliber. I basically built a budget 16” carbine. I have a few of the E-Lander Grendel mags(which given that I did an almost identical build in 6.5 Grendel, worked out pretty well).

I’m going to be reloading a chunk of my ammo. I’ve been scrounging components to that end. I’ve been into ARs and reloading for a number of years, so not new to either. Just new to 6.8 SPC. I am excited to see that cast loads are possible with it.

I hope to learn more about 6.8 here!
 

·
Super Moderator
Joined
·
1,883 Posts
I'm sure you've seen the reloading section...

Welcome from SE GA!
 

·
Registered
Joined
·
611 Posts
Welcome to the forum from Western Ohio.
 

·
Administrator
Joined
·
22,870 Posts
Welcome to the fray.
 
1 - 8 of 8 Posts
Top