6.8 SPC Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
905 Posts
Discussion Starter · #5 ·
It's one of the old KT barrels with a SPCII chamber and a 1:9.5 twist, so most loads are a little too hot. To combat that problem, I just load a little less than what is recommended and I usually don't have a problem.

I finally had the time to run the Tubbs FF system through it and I noticed a huge difference. Not only did it make cleaning the rifle a hell of a lot easier, but on loads that were causing slight swipes were running perfectly fine.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top