6.8 SPC Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
2,318 Posts
Discussion Starter #1
I have a DNTC308 with a crush washer that if anyone is interested, you can have it for free. If anyone is interested just reply to this thread. First come, first serve basis. And of course it will work with any 6.8SPC or .308 barrel that has the 5/8x24 threads. It only has a couple of hundred rounds. I replaced it with the FSC30.

http://primaryweapons.com/store/pc/viewPrd.asp?idcategory=5&idproduct=5
 

·
Registered
Joined
·
34 Posts
paulosantos said:
I have a DNTC308 with a crush washer that if anyone is interested, you can have it for free. If anyone is interested just reply to this thread. First come, first serve basis. And of course it will work with any 6.8SPC or .308 barrel that has the 5/8x24 threads. It only has a couple of hundred rounds. I replaced it with the FSC30.

http://primaryweapons.com/store/pc/viewPrd.asp?idcategory=5&idproduct=5

I'll take it. Make a nice thread protector for my savage.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top