6.8 SPC Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,450 Posts
Discussion Starter #1
I contacted
Chris("the smith") at Cold War Shooters and this is what I have.

Chris has some 25 rd Cproducts mags for those that dont mind them but he can get and modify whatever mags you choose (pro-mag-Pri-Barrett)... The modification is permanent so the follower and the spring cannot be replaced once it is done...

according to c-products there is no reason to modify the mag spring or follower if it is a 10/25 becuase less than half capacity is being used at all times....

if you want the good cs springs and different followers you have to provide them to Chris before he begins...

the number there is 909-425-1300
 

·
Registered
Joined
·
0 Posts
That's great news for us in Kalifostan! Coldwar Shooters is 45 minutes away for me.
I should have my 6.8 built by Christmas... Unless of course the dems decide to cancel the holiday.
 

·
Registered
Joined
·
441 Posts
If you guys do that get PRI mags and then get SSS or ISMI mag springs for them. Since it is permanent you want stuff in there that will last forever.
 

·
Registered
Joined
·
1,450 Posts
Discussion Starter #4
Tim_W said:
If you guys do that get PRI mags and then get SSS or ISMI mag springs for them. Since it is permanent you want stuff in there that will last forever.
I will definately do this to my 10 rounders....

but the 10/25 will cost a fortune with the PRI mags @ 40.00+ and springs @ 10.00+ and the cost of the gunsmiths labor per mag.... I am going to try a couple c-products mags and see how they work...

thanks Tim
 
1 - 4 of 4 Posts
Top