[Drof]

OK I messed up and bought an aac 7.62sd for my .308 and 6.8. I thought which was my mistake that my barrel was threaded to the norm of 5/8 24RH. Well turns out my stag barrel is 1/2X36 and AAC doesn't make a qd in that config.

Sooooooo do I have my barrel redone to the 5/8X24(if so who would you guys trust to do this sense I'm going to be screwing a suppressor on the end of it?) or do I go ahead and buy a xtreme barrel? The xtreme barrel is 5/8X24 right? or am I still thinking to much?

I mean if it costs half the price of the xtreme barrel or more I would just rather have the new barrel, but If you guys know who could square away my situation for much less with trustworthy work I would go that route.

 

[ron169]

http://primaryweapons.com/store/pc/view ... category=4

You may want to contact them, I thought they adapted from 1/2x36 to a 5/8X24 but I dunno. If they dont im sure they could tell you where to get the adapter from. Now as for who you could use to rethread your barrel, probably ADCO if I had to guess, but what is going to kill you is the shipping to and from. Most gunsmiths could probably do it so check your area

 

[BillBond]

+1 on having ADCO thread your barrel.
Shipping will be less than the cost of driving around.
I use USPS priority mail when shipping to ADCO

8)

 

[HTR]

There is a much simpler solution:

Call or visit by web, Mark McWillis at TROS. They make adapters for all sorts of threads. I use one of theirs for my 1/2 X 28 threads so that I may mount my 5/8 X 24 can on 5.56's.

They are guaranteed to be concentric. They are not expensive, either

 

[Drof]

Thanks, I didn't even think about an adapter! I'll go that route for now.