6.8 SPC Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Does anybody know if replacement springs can be had for the Barrett mags? In anticipation of Obama, mags need to be serviceable, and since the mags aren't standard length, I didn't know if Barrett had rebuild parts available. That was one of the downfalls of the HK 5.56 mag.
 

·
Registered
Joined
·
410 Posts
I pulled the spring out of a Barrett and compared it to an ISMI spring and they were the same length. I didn't put the ISMI in the mag and am not sure about compression rates and all that stuff, but it might work. Another thing you could try is calling Barrett to see if they offer them. Of course, the last time I called them the lady I spoke to was pretty cranky and short on the phone, so good luck.
 
1 - 2 of 2 Posts
Top