Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!

Adj gas block question

968 Views 4 Replies 4 Participants Last post by Blowout, Jan 31, 2017

sigpros

Discussion Starter · Jan 15, 2017

Ok so I got my pa10 all put togther and ran a few rounds through it just to function test. Pmc was ejecting at 1-2 o'clock and Tula (I know but panic ammo I picked up cheap) was at 3 0'clock. I put my scope on and I am going to install my mount and yhm lta on it and sight it in on Wednesday. So where do I want the ejection at? I'm new to adj gas blocks and want to set it up right the first time.

Save

1 - 5 of 5 Posts

semi_cop

· #2 · Jan 15, 2017 (Edited)

sigpros said:
Ok so I got my pa10 all put togther and ran a few rounds through it just to function test. Pmc was ejecting at 1-2 o'clock and Tula (I know but panic ammo I picked up cheap) was at 3 0'clock. I put my scope on and I am going to install my mount and yhm lta on it and sight it in on Wednesday. So where do I want the ejection at? I'm new to adj gas blocks and want to set it up right the first time.

If it's ejecting 1-2 o'clock is it bouncing off the deflector?

You want to adjust the gas down until the bolt carrier will lock back on the bolt face.

Turn the gas down until it fails to lock back then open it until it fully locks open.

See less See more

Save

sigpros

Discussion Starter · #3 · Jan 15, 2017

Thank you for that.

Save

32degreerifleman

· #4 · Jan 16, 2017

"normally" if you set up your block to run Tula out at 4:30 good ammo usually comes in at 3:00-3:30.

Save

Blowout

· #5 · Jan 31, 2017

Good diagram shown in this thread to help determine cause and effect.

i like the 6:00 - 12:00 cause... lol

Save

1 - 5 of 5 Posts

Top Contributors this Month