6.8 SPC Forums banner
  • Hey Guest, it looks like you haven't made your first post yet. Until you make an introduction thread, the rest of the site is locked to posting. Why not take a few minutes to say hi!
1 - 8 of 8 Posts

· Registered
Joined
·
677 Posts
Discussion Starter · #1 ·
I ended up with some 90 grain 6mm TGK bullets and thought about trying them in my 6x6.8. Has anyone tried them in the 6x6.8? Load data? Accuracy? Game performance, etc?

Thanks
 

· Registered
Joined
·
677 Posts
Discussion Starter · #4 ·
Thanks.

Been doing some measurements. Maximum OAL in my ASC mags is 2.295”. There maybe a problem with too much of the bullet seated inside of the case, past the bullet’s ogive. Not sure if that would be an issue or not.
 

· Super Moderator
Joined
·
1,982 Posts
Not sure what you use to figure max OAL to the lands. Make sure your "mag length round" doesn't put you "in a jam." (pun intended)
 

· Registered
Joined
·
677 Posts
Discussion Starter · #6 ·
Not sure what you use to figure max OAL to the lands. Make sure your "mag length round" doesn't put you "in a jam." (pun intended)
Im using the Stoney Point OAL gauge with the 6x6.8 modified case. No problem jamming. It contacts them at 2.395”. I’ll have a min jump at least .100”
 
  • Like
Reactions: greentick

· Registered
Joined
·
677 Posts
Discussion Starter · #8 ·
1 - 8 of 8 Posts
Top